This project is read-only.

Problem with isdn Controller

May 30, 2010 at 4:15 PM
Edited May 30, 2010 at 4:28 PM

Hey,

Im using a AVM isdn Controller ("FRITZ!Card PCI").

The device is detected and i can choose it in the "Controler Combobox", but when i try to dail nothing happens (the listbox shows: "D_ConnectPending" and "D_DisconnectPending" or only "Disconnected") and Incoming calls are not detected too.

So is there something to consider, before using?

Thank for your help ;)

 

Regards,

Anti

Coordinator
May 30, 2010 at 4:35 PM
Hi Anti,
Do you see some exception in output window when debugging?

Regards
Michail
On May 30, 2010, at 6:15 PM, iAnti wrote:

From: iAnti

Hey,

Im using a AVM isdn Controller ("FRITZ!Card PCI").

The device is detected and i can choose it in the "Controler Combobox", but when i try to dail nothing happens (the listbox shows: "Connect Pending" and "Disconnect Pending") and Incoming calls are not detected too.

So is there something to consider?

Thank for your help ;)


Regards,

Anti

Read the full discussion online.

To add a post to this discussion, reply to this email (CAPI@discussions.codeplex.com)

To start a new discussion for this project, email CAPI@discussions.codeplex.com

You are receiving this email because you subscribed to this discussion on CodePlex. You can unsubscribe or change your settings on codePlex.com.

Please note: Images and attachments will be removed from emails. Any posts to this discussion will also be available online at codeplex.com